Tuesday, July 28, 2009

Got Holes?

I almost titled this post, "The most boring post ever in the history of mankind," or, "Read this to your kids to help them fall asleep tonight." Or, "Warning: Drowsiness may occur as a result of reading this post."

But instead, I came up with "Got Holes?" Works, eh?

So if the builder in your house was towel rod happy like ours was, you've probably got lots of these:

I mean, they were giddy with these things. We had a loooong one in our powder room -- for bath towels. And there's no bath in there. Or shower. Giddy.

First off, if there are anchors in the wall (and builders are anchor-happy too), it's pretty easy to get them out. Take a pair of needle-nosed pliers and get in there and grab the anchor:

Pull it and it should come out fairly easily. If it won't, try pounding it back into the wall and through. Either way you'll be left with a massive hole. It will be way bigger than the anchor seemed to be, but just relax peeps! I got your back!

Next is my little trick I learned awhile back. If you go to fill the hole as is, it will take a ton of spackle to fill it in. Instead, before you fill, take some thick paper -- I've used grocery bags and lately these little annoying-as-crap mailers that come out of the magazines:

Tear off little pieces and stuff them into the holes:
This gives the spackle something to lay on and grab ahold of. (By the way, the fun little ring around the holes happens when you have zero patience after painting a wall and are dying to get the rods back up. Yeah. Don't do that.)

Then take your loverly spackle that you mostly use for these (textured stencils) and not what it's intended for:

And frost the holes with it. It's fun. Try it.
Keep frosting till you've covered the holes, using the scraper to take off the excess and then reapplying a few times. I like to leave a little smudge of extra on top so the holes are covered really well:
After it's dry sand it down a bit and reapply if needed. Wipe down after sanding well, wiping off all excess spackle you can. Then find your paint, freak out when all you have is the eggshell finish and not the semi gloss finish you need, say what the heck, no one will ever notice, and use a small foam brush to paint over the spots.

I have to tell you -- be very selective where you put anchors in your walls. Generally you will ALWAYS see where they were, no matter how well you patch them up. Anchors tend to pull the drywall up around them a bit, so the drywall is never quite flat. But I promise unless you are really looking, you will never notice them again:
See?? Told ya! If you are patching small nail holes, just use your finger and put a little smudge in the hole. Just a little dab. Just a smooch. Like you're kissin' your sister. (Name that movie!!)

It may just be because I'm the freak I am, but even the smallest changes make a huge difference to me. Before, the towel rod was the first thing you saw in our bathroom:

Now, it's my pretty little bench and my enormous shower curtain:

And the iron scrolly jobby isn't hanging at giant eye level anymore, it's at human eye level. All is right with the world. I filled about 14 holes yesterday, and it only took an hour, total, to do it all.

Easy peasy Squeezy! You go by Squeezy now. Just so you know.

Any other good patchin' tips? Share them in the comments!

0 comments:

Post a Comment

 
Copyright 2010 Camera Dashboard. All rights reserved.
Themes by Ex Templates Blogger Templates l Home Recordings l Studio Rekaman